Cytuję za informacją
->User Calibration.pdf z pierwszej strony zacytowanego wątku (no faktycznie Ci się nie chciało
):
"iCharger User Calibration
The iCharger has been calibrated before entering to the markets, but if the users find that there is too
much deviation, you can calibrate it as the following items:
These steps are suitable for 1010B+, 1010B, 106B+, 106B and 208B, but only useful for 3.09
version and further version in the future.Before calibration, you need prepare:
> battery pack (the individual voltage ranges from 3.9-4.2V)
1010B(+)……10s 106(+)……6s 208B……8s
> 4+1/2 Digital Multimeter
> Steadily 12V input power supply
Calibrating steps:
1. Press <Stop><Dec><Inc><Start> these 4 buttons together, then electrify the iCharger; loose the
buttons when hearing 3 beeps from the buzzer.
2. Connect the battery to the iCharger charging port and the balance port.
3. After starting the charger, hold <Stop> button for 3 seconds to the monitor interface.
4. Press <Inc> or <Start> button to choose your "need-to-be calibrated" voltage screen, then hold
<Dec>< Inc ><Start> three buttons for 3 seconds at the same time to calibration state.
5. The "need-to-be calibrated" voltage begins blink (the voltage value and the calibrate value showed
on the screen alternatively). At this time, you can calibrate the iCharger by the value your digital
multimeter reads, pressing <Inc> to increase and <Dec> to decrease. Press <Start>, then you can
switch the calibrated voltage; press <Stop> to quit from calibration state. The step 3 and 4 can be
repeated several times to calibrate all the voltage.
6. Press <Stop> to quit and if you need to calibrate next time, you need begin from the 1st step.
Warning:
1. When calibrating, you need clear the voltage source.
2. Step 1 and 2 cannot be in reverse order.
3. If the user calibrates it in a wrong way, which damage the battery or cause other serious danger, our
company will be of no responsibility.
Note:
Version V3.09 & V3.10 has some bugs on “Vo” calibration, V3.11 and the future version have modified
these bugs:
Use these 2 points of calibration method, to ensure voltage can be well calibrated:
> Connecting nS batteries,and calibrate ”Vo” first。(1010B(+): n=10 106(+):n=6 208B:n=8)
> Then connection 3S(11-13V) batteries,and calibrate ”Vo”。By Junsi 2009-08-11 V4"