Tak, nadeszła chwila że Beastx się 100% z kompa da ustawić.
Jest też wersja V5 i nowe możliwości o tym za chwile narazie zdążyłem sprawdzić że update z wersji 4.2.x do 5.1.x jest darmowy ( wcześniej zapłaciłem 79€ za up z 4.0 do 4.2).
Natomiast z wersji 4.0.0 do wersji 5 (bez attitudecontrol/nie mylić z rescue bo to zupełnie co innego) kosztuje 20€ a pełna funkcjonalność 99€ mega drogo moim zdaniem drugiej sztuki AR7210BX narazie nie podnoszę.
Co nowego?
Narazie tylko poczytałem, otuż mamy coś nazwane Bank, mamy Logi, mamy nowe atti.
Bank 1,2,3 - z tego co zrozumiałem to możemy pod przełącznik ustawić sobie 3 rodzaje Atti.
Logi - nic tu narazie nie widzę
Atti czyli - Leveling modes (po ich niemu).
Angular Mode
In this mode the helicopter flies like a quad copter. You have full control over pitch, but pushing aileron or elevator will only cause the helicopter to tilt by a given angle instead of rotating it around the roll or pitch axis. This makes flying much easier as you can't flip over the helicopter. Instead the maximum tilt is limited by your stick input. (Note: If you want to train inverted hovering using the angular mode, you will have to bring the helicopter into inverted position with AttitudeControl disabled first and then activate it).
Bailout rescue
The rescue mode can be used to bring the helicopter into a safe and well known position in case you loose orientation. No matter in which position the helicopter is at the moment, upright or inverted, once you activate the bailout rescue the system will bring your helicopter into an upright hovering position. In addition you set the Attitude Mode to "Bailout rescue with Pitch", here the system also will add some collective pitch input, so the helicopter hovers even when you have the thrust stick set at negative pitch position by accident. Or you could add even more pitch so the helicopter gains height quickly (for this pupose you can also use the "rescue boost" which can be set using the StudioXm App or StudioX Software).
3D - Mode
This basically does the same as the rescue mode but difference is that it will also level the helicopter in inverted position. Here the system detects which position is closer to reach and directly levels the helicopter without making a turn around. This can be used when you want to train and learn aerobatic maneuvers, like inverted hovering, flips or ticotcs. As you can override the AttitudeControl by adding some cyclic stick input even you could let AttitudeControl activated for a longer time, so the system guides you like a helping hand. I.e. when you make a front flip you only have to concentrate on giving correct collective pitch input. The elevator does not have to be as precise, as the exact leveling when reaching inverted hovering position is done by attitude control, even the system will pull the helicopter into level position, once it is tilted more than 90 degrees to the front. Please note the system will not level the heli into on or the other direction when it is in vertical position. This makes it more comfortable to fly around and perform loopings or knife edge flying while 3D Mode is active!
Besides the general choice from theses 5 Modes (Angular Mode, Bailout rescue, Bailout rescue with Pitch, 3D - Mode, 3D - Mode with Pitch) you can adjust more options with the StudioX Software or StudioXm App. For example you can add some boost pitch for a short amount of time so the helicopter gains height quickly, or you can lock the thrust stick input. These options are described later in detail. Also note that when using Bankswitching (Flight mode switching) you can set different Attitude modes and options for each flight mode and tweak the system to your likings even more.
Nie masz wymaganych uprawnień, aby zobaczyć pliki załączone do tego posta.
Czyli jeden klik = kilka setek w kieszeni. Mogę dalej ćwiczyć a nie siedzieć nad odbudową. 
