positive rail for the ESC ports is on the OUTSIDE of the board, so you have to re-pin your servo connectors in order to not short things out. Apparently this was done because having the positive rail in the middle -- as is standard -- caused issues with the mag sensor (2.54mm closer inboard). Sounds to me like a better solution would have been to relocate the mag.
The quality thing derrick mentioned is because he had one that had a sensor that was DOA (I forget if it was the mag or baro that didn't work). tc himself has mentioned the quality of the flip32's to be lower as well, though I'm not sure in what way(s).
wojtekr pisze:Widzę, że mnie ignorujecie
[...]
Wygląda, na to że nie bardzo jest jak połączyć je ze sobą. Przynajmniej dokumentacji nie ma na ten temat.
miruuu pisze:Ja myślę że Wojtek po prostu sprzedał uszkodzone.
Ściuś, Ściuś Wojtek...
Wróć do „Systemy FC (Flight Controller)”
Użytkownicy przeglądający to forum: Obecnie na forum nie ma żadnego zarejestrowanego użytkownika i 6 gości